Circlips Basic Type

Circlips basic type available from Fastenright in a range of designs, internal and external, from basic to heavy-duty.

Basic circlips come in internal and external styles, with the former used for housing bores. Internal Basic Circlips host a tapered design that permits rings to maintain a constant and consistent circularity and pressure against the bottom of its groove. The external version, used in shafts, features a tapered design for similar reasoning to the internal version.

Heavy Duty Circlips are usually for external use in shafts, where the heavy-duty ring is resistant to high trust and impact loads, providing greater-load supporting.

There are two types of Inverted Circlips, for internal and external use. The internal is used in housing bores and provide uniform protruding shoulders whilst maintaining their constant circularity, whilst the external are for shafts.

There are also Miniature High-Strength Circlips for use in small shafts, which host a tamper-proof shoulder – subject to heavy thrusts and impact loads.

Please contact us with your requirements to further your enquiry.

	BASIC	INTERNAL FOR HOUSING BORES	TAPERED DESIGN PRINCIPLE PERMITS RINGS TO MAINTAIN CONSTANT CIRCULARITY AND PRESSURE AGAINST BOTTOM OF GROOVE
	BASIC	EXTERNAL FOR SHAFTS	TAPERED DESIGN PRINCIPLE PERMITS RINGS TO MAINTAIN CONSTANT CIRCULARITY AND PRESSURE AGAINST BOTTOM OF GROOVE
	HEAVY DUTY	EXTERNAL FOR SHAFTS	HEAVY DUTY RING RESISTANT TO HIGH THRUST AND IMPACT LOADS, GREATER LOAD-SUPPORTING
	INVERTED	INTERNAL FOR HOUSING BORES	INVERTED CONSTRUCTION PROVIDES UNIFORM PROTRUDING SHOULDERS WHILE MAINTAINING CONSTANT CIRCULARITY WHEN INSTALLED IN GROOVE
	INVERTED	EXTERNAL FOR SHAFTS	INVERTED CONSTRUCTION PROVIDES UNIFORM PROTRUDING SHOULDERS WHILE MAINTAINING CONSTANT CIRCULARITY WHEN INSTALLED IN GROOVE
	MINIATURE HIGH-STRENGTH	EXTERNAL FOR SMALL SHAFTS	MINIATURE HIGH-STRENGTH RING, PROVIDES TAMPER PROOF SHOULDER ON SMALL DIAMETER SHAFT, SUBJECT TO HEAVY THRUSTS AND IMPACT LOADS